2019/01/21 15:00 | Pageview:2585 | From: repairerdrivennews
The fall 2018 edition explains why an OEM might want collision repairers to rivet-bond their aluminum parts with a combination of a fastener and adhesive rather than pull out a welder.
According to Ford, spot-welding aluminum is difficult for an OEM, and it can't be done in the aftermarket.
"Aluminum welding requires highly specialized weld units and procedures (pre-heating and post-heating), along with a slow cool down, that make it unfeasible for the average repair shop," Ford wrote.
This is an important reminder to follow the OEM repair procedures, even when those instructions call for a method different than the factory's. Ford might be able to spot-weld aluminum, but your shop can't — and your attempting to do so might harm the metal and yield an unsafe repair.
Besides, Auto/Steel Partnership research has demonstrated that a combination of rivet and adhesive can bond two pieces of ultra-high-strength steel better than a factory spot weld.
Ford explained in On Topic that aluminum welding needs triple the power of steel, can make the metal brittle and can be compromised (insufficient penetration) by the oxide layer quickly arising on aluminum.
Rivet-bonding avoids those heat complications and creates too tight a fit for corrosion to occur, according to On Target.
On Target also provided reader-friendly explanations on the differences between pull-style, self-piercing and flow-form rivets. It helps drive home Ford's assertion that rivets aren't necessarily interchangeable, and often neither are riveting tools.
"For the most part, each type of rivet requires its own installation tooling. If the proper tooling is not used, the workpiece could be distorted, or not enough clamping force will be delivered to successfully install the rivet," Ford wrote.
"When beginning a repair, it is important to make sure you are using the right rivet for that repair. First, check the OEM recommendation or the rivet part number, and then order the rivets per repair. Each type of rivet is classified by the OEM for grip range, coating and strength, with part numbers indicated for repair rivets."
Using the exact adhesive required by the OEM in the joint also matters, according to Ford.
Slide, don't lift a roof during alignment: "It is critical that repairers do not lift the new roof panel when aligning to the index marks," senior damageability engineer Gerry Bonanni warned, according to On Target. "Instead, repairers should slide the new panel into position. This will reduce the possibility of breaking the adhesive bond."
Embrace the adhesive overflow: Repairers shouldn't "remove any excess adhesive that squeezes out in the roof-ditch area," according to Ford. "Instead, it should be smoothed into the joint to act as additional sealer."
Don't stick a new self-piercing rivet where the old one was: "SPR fasteners cannot be placed directly over the original SPR location," Bonanni said, according to On Target. "They must be placed adjacent to the original location matching the original quantity. Blind or solid rivets may be used in place of SPRs in the original SPR location, but only after it is widened to 6.5 millimeters."